BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT — Save these instructions for local inspector’s use.• IMPORTANT — Obs
2 B ABERTURA PARA HORNOS ÚNICOS – BAJO EL MOSTRADOR DE ENCIMERANOTA: Estos hornos sólo pueden instalarse bajo los modelos específicos como se indica
2 D ABERTURA PARA INSTALACIÓN SOBRE UN CAJÓN CALENTADORNOTA: Instale el horno sólo con los modelos específicos listados en la etiqueta ubicada en la
3 INSTALACIÓN DEL RIEL CON PEDESTAL (HORNOS DOBLES ÚNICAMENTE)A. Coloque un riel con pedestal en cada rodadura del gabinete o centrado en el lado op
4 REMOCIÓN DE LA PUERTA (recomendada)NOTA: La remoción de la puerta no es un requerimiento de la instalación del producto, pero es una comodidad adi
6 REALICE LAS CONEXIONES ELÉCTRICAS ADVERTENCIA: Desconecte la energía del panel de servicio y bloquee los medios de desconexión para evitar el accio
10 INSTALE EL HORNOADVERTENCIA: Deben utilizarse tornillos de montaje. Si no lo hace, el horno puede caer del gabinete, lo que provocaría una lesión
13 CÓMO VOLVER A COLOCAR LA PUERTA DEL HORNONOTA: La puerta del horno es pesada. Puede necesitar ayuda para levantar la puerta lo suficiente como para
2 A CUTOUT FOR SINGLE OVENS IN WALL CABINETNOTE: If the cabinet does not have a front frame and the sides are less than ¾” (1.9 cm) thick, shim both
2 C CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS)NOTE: If the cabinet does not have a front frame and the sides are less than ¾” (1.9 cm) thick, shim bot
3 PEDESTAL RAIL INSTALLATION (DOUBLE OVENS ONLY)A. Place one pedestal rail on each cabinet runner or centered on opposite side of solid cabinet bott
4 DOOR REMOVAL (RECOMMENDED)NOTE: Door removal is not a requirement for installation of the product but is an added convenience.To remove the door:A.
6 MAKE ELECTRICAL CONNECTIONSWARNING: Switch power off at the service panel and lock the service disconnecting means to prevent power from being sw
11 BOTTOM TRIM INSTALLATION• With oven installed, attach the bottom trim through its mounting holes in front vertical brace using two trim screws pr
12 OVEN RACK GUIDE INSTALLATION (IF APPLICABLE)A. Locate included oven rack guide mouting hardware.B. Place oven rack guides on cavity wall studs wi
ANTES DE COMENZARLea estas instrucciones por completo y con detenimiento. • IMPORTANTE — Guarde estas instrucciones para el uso de inspectores local
Comments to this Manuals