GE Appliances JX7230DFBB Installation Guide download pdf (Page 2)

CUTOUT DIMENSIONS

* Min. depth with receptacle outside cabinet 19

ø2”

Min. depth with receptacle inside cabinet 22”

Installation Instructions

Models 27” 30”

Height 16

ø4” 16

ø4”

Width 25

ø2” 25

ø2”

Depth (min.)* 19

ø2” or 22” 19

ø2” or 22”

On 27” models, allow 1

ø4” at the top,

ø16” on the sides

and 1” at the bottom for overlap of the Trim Frame over

the edges of the cutout.

On 30” models, allow 1

ø4”at the top, 2

ø8” on the sides

and 1”at the bottom for overlap of the Trim Frame over

the edges of the cutout.

For ADA Compliance, the microwave must be installed

no higher than 36

ø4”.

Depth

Height

”overlap

Width

INSTALL BOTTOM BRACKET AND

BOTTOM DUCT

Fit the tab on the bottom bracket into the slot on the

back of the bottom duct, and push down until the

bracket is flush with the bottom of the duct. Fasten

the bottom bracket to the bottom duct by using two

round-head screws.

Disconnect the microwave oven before proceeding

with the installation.

Remove any loose items inside the microwave

oven, including the turntable and turntable support.

Carefully turn the microwave oven upside down.

Line up the tabs on the bottom duct with the slots

on the bottom of the microwave and insert the tabs

into the slots. Secure the bottom duct with four

round-head screws as shown.

Front

Rear

Screws

Microwave Oven Upside Down

ø4” overlap

1” Clearance

beyond Trim Frame

(on all sides)

” Models:

ø16”overlap

30” Models: 2

ø8” overlap

” min.

CAUTION

This trim kit uses air flow from the top, bottom and

sides of the trim frame. Blocking the air flow can

cause the microwave to function improperly and may

cause damage to the microwave.

Allow a 1” clearance beyond the edge of the Trim

Frame to provide proper air flow.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

GE Appliances JX7230DFBB Installation Guide Page 2

Comments to this Manuals

Related products and manuals for Unknown GE Appliances JX7230DFBB