GE Appliances JVM3160RFSS Installation Guide download pdf (Page 17)

USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws,

a hole large enough for the power cord to fit through,

and a cutout large enough for the exhaust adaptor.

 Read the instructions on the TOP CABINET TEMPLATE.

 Tape it underneath the top cabinet.

 Drill the holes, following the instructions on the TOP

CABINET TEMPLATE.

CAUTION::HDUVDIHW\JRJJOHVZKHQ

GULOOLQJKROHVLQWKHFDELQHWERWWRP

Installation Instructions

ADJUST BLOWER MOTOR

$'-867%/2:(502725FRQW

Remove the screws holding the blower unit and

the screws securing the blower plate. Remove

the blower plate from the outer case by sliding it

toward the back of the microwave and pulling up.

Blower Plate

Blower Motor Screws

Blower

Motor

Screw

Carefully pull out the blower unit. The wires will

extend far enough to allow you to adjust the

blower unit.

Roll the blower so that fan blade openings are

facing the top of the oven. Place the blower back

into the opening.

Slide the blower plate back onto the microwave

by placing the side tabs into the slots and pushing

gently until the back tab is seated into the rear slot.

Replace 3 screws.

Note: Make sure the wires remain routed through the

openings in the motor frame. To avoid damage to

the fan motor wiring, insert motor carefully such that

the fan motor wiring does not contact the microwave

power cord bracket.

Back of

Mircrowave

Rotate 90°

Back of

Mircrowave

Fan Blades

Wires

WARNING: 5LVNRI(OHFWULF6KRFN

Can cause injury or death. Do not pull or stretch the

EORZHUXQLWZLULQJ0DNHVXUHWKHZLUHVDUHQRW

pinched.

Side Tab

Side Slot

Rear Slot

Rear Tab

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comments to this Manuals

No comments

GE Appliances JVM3160RFSS Installation Guide Page 17

Comments to this Manuals

Related products and manuals for Microwaves GE Appliances JVM3160RFSS